Encore ENLGA-1320 Specifiche

FCC Statement This device compiles with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not caus

1. Introduction Thanks for the purchasing of your new Gigabit Ethernet PCI adapter. This document describes the Installation of network adapter. This

1.2 System Requirements To use the adapter, you need the following components:  One 32 or 64 bit PCI master mode expansion slot that is compliant wi

3. Install the Adapter 1. Turn off the computer. 2. Remove the computer’s cover, in accordance to its manual. 3. Insert the contact edge of the a

5. Software Installation Microsoft Windows 98SE 1. Plug the adapter into the PCI slot. 2. Press the power button on the case of PC to turn it on 3.

4. Click "Have Disk" for selecting one network adapter. 5. Insert this driver disk in drive A, enter drive and pathname “A:\Winnt4”, then

<NEXT> button. 5. Windows XP will prompt "Gigabit Ethernet Network Adapter " in "Hardware Installation" dialog box, click &

"cp r8169.o /lib/modules/<kernel>/kernel/drivers/net" where <kernel> represents the kernel version, say 2.4.18-3 in Red Hat

Novell Netware System (5.X/6.X) 1. Run NetWare Server System. 2. When the Server prompt appears, load the NetWare Server Installation Utility =